Gate Installation

Gate Operators and Traffic Controls

Specialty Doors + Automation offers gate installation on a full line of name-brand gate operators, including Elite, Apollo, Doorking and PowerMaster

Specialty Doors + Automation  specializes in gates and controls.  We offer a full line of solutions for your automatic gate needs.  We carry Elite Access and Doorking Systems that include Commercial slide gate operators, swing gate operators, and Entry Phone Systems for residential and commercial high-traffic operators.

We can help you customize a solution based on your needs and the amount of traffic flow. Visit our contact page and fill out the form and we will contact you to discuss your needs further. Technical Assistance is just one call away. We can walk you through your project from design to service.

TURN-KEY SOLUTIONS

• Gate Operators
• Access Controls
• Phone Entry Systmes
• Transmitters
• Gate Hardware
• Traffic Control Equipment
• Loop Detectors
• Engineering & Layout

• Same Day Service
• Complete Fabrication
• Electrical
• 24 hour emergency
• 100% Satisfaction Guarantee
• No Travel Charge for local area
• Free Safety Inspection

SLIDE GATE OPERATORS
2-way Reversing Sensor (standard)

The digital current sensor continuously monitors the motor current. It can be set for both the opening or closing cycles. If the gate is closing and hits a vehicle, the sensor detects the increased load on the motor and reverses, If the gate is opening and hits a vehicle, it stops. The sensor is smart enough to not react to wind resistance or operation on off-level installations.

SWING GATE OPERATORS
Non-scissor-action Arm (standard)

Most swing gate operator arms will cross and product a dangerous "scissor action" while opening the gate to a 90 degree opening, as shown in picture "A". We designed our CSW-200 operator arms to not cross, eliminating the scissor action as shown in picture "B". This feature reduces the risk of injury from the gate operator arm.

2-way Reversing Sensor (standard)

The digital current sensor continuously monitors the motor current. It can be set for both the opening or closing cycles. If the gate is closing and hits a vehicle, the sensor detects the increased load on the motor and reverses, If the gate is opening and hits a vehicle, it stops. The sensor is smart enough to not react to wind resistance or operation on off-level installations.